General Specifications as per OEM brochure. Buyer should verify details. Equipped with: Both long and short legs. Handheld Remote Manuals Originally configured on Eurotech Barely used. Replacement cost about $15K General Specifications: TECHNICAL SPECIFICATION from Manual Scope of application Bar dimension Bar round cross section: 6 to 67 mm Bar hexagonal cross section: 8 to 58 mm Bar square cross section: 8 to 47 mm Bar weight Maximum weight of the loaded bar: 60 kg Bar length Maximum length of the bar: 1525 mm Magazine capacity depending on the bar diameter 8 bars: 80 mm The # of bars limited by the table cap 6 mm Max Weight of all bars on Table: 250 kg Pusher stroke Design stroke: 1665 mm Working stroke: 1660 mm Max dist of the clamping device face 1655 mm from the pusher point in back position Technology of bar handling The bar is cantered in the lathe spindle by spindle inserts, and shifted by the pusher to a stopper in the tool head. Bar loading cycle: approx. 30 s Setting time at change of bar diameter: Max. 1 minute at change diameter + time of lathe spindle insert replacement Electrical equipment Power supply: 200/230/400 VAC, 50/60 Hz, 320 VA Power circuits: 200 VAC, 24 VDC Logic circuits: 24 VDC Weight: approx. 375 kg Transport dimensions: L 2230 x W 1150 x H 1220 mm CONCEPT The barfeeder ML-565/580 T/S is a powerful machine with a long service life and minimal maintenance required. Its operation and functions are simple which facilitates the work even to less skilled workers. The barfeeder is controlled by means of the control panel in the right part of the machine. There is an E-Stop pushbutton for emergency stop on the control panel. In the left part of the barfeeder frame there is a Q1 switch. Bars are loaded in the magazine. Loading of bars into the lathe is ensured by a loading channel with a flag and pusher. On the rear side of the frame there are connectors X1, X2 for barfeeder interconnection with the lathe.
to complete inventory display
to our home page