IEMCA I-FLEX-6, 6', .315" - 3.150", Fixed Headstock, NEW   Our stock number: 319923

IEMCA I-FLEX-6, 6', .315 - 3.150 , Fixed Headstock, NEW

General Specifications As Per Brochure:

Bar Size Capacity:                             .315"-3.150"
Bar Length Capacity:                           6
Maximum Bar Length:                            7'6"
Minimum Bar Length:                            39"
Magazine Capacity:                             12.5 Linear Inches
Maximim Remnant Retract:                       15" up to 2.55" diameter
                                               10" for longer diameters
Operating Voltage:                             230V AC 3 phase
Control Voltage:                               24 Volts DC
Total Power Required:                          4 KVA/3.0 KW
Compressed Air Required:                       90 PSI, 1 CFM
Guide Channel Oil:                             ISO 150, Quantity 25 Gallon
Feeding Speed:                                 6"/Sec
Facing Accuracy:                               +/- .020"
Bar Change Time:                               30 sec for 6' Bar
Bar Straightness Requirment:                   .007"/foot
Bar feeder Shipping Weight:                    2500 lbs

Standard Equipment Includes:
Custom Electrical Cable Package & Interface Kit
Remnant Retract, Bushing Device
24" Z Axis Displacement
Guide Channel Set Includes:
  1 Nose, 1 Rotating Tip, 1 Split Bushing, 1 Collet

Options:

Package A:

I-Flex-6 with two complete guide channel sets for loading 6' bar     $41,990

Package B:

I-Flex-6 with three complete guide channel sets for loading 6' bar  $ 43,990



Category III Interface:                                             $ 1,400
Special Adaptation Kit;                                             $ 1,600

Installation:

IEMCA/Bucci USA Installation:                                       $ 3,100
 (Includes Labor, Travel and 12 Month Warranty)

Important Notes:

Bar Feeder Installation does not include lathe-side software or hardware for

magazine bar feeder interface.This interface must be supplied and installed by

the lathe OEM or Distributor, prior to bar feeder installation.Maximum Bar

diameters are for front ejection of the remnant. For remnant retraction,

maximum diametersare slightly less. Bar straightness, proper guide channel

selection, correct alignment and anchoring ofbar feeder will ensure optimum

performance at maximum rpm.












Get a Quote

Company:
Contact:
Email:
Tel:
Address:
City St ZIP:
Fax:

How did you hear of us?
Additional information on your request:
   

Please enter text from above:

RETURN to complete inventory display       RETURN to our home page