General Specifications as per Brochure: Technical Specifications: Bar diameter capacity: 2mm to 20mm (.078" - .787") Max. bar length: 3800mm (12' 5") Min. bar length: 10000mm (39.4") magazine remnant length: 420mm (16.5") Magazine rack capacity: 7" Bar loading cycle time: 17 seconds for 12' bar Material straightness specification: .007" TIR/foot of material (V blocks, 3 points equidistant) Feed force (pusher torque): max. 300 N, adjustable Forward feed rate: 710 IPM, adjustable Return feed rate: 1420 IPM, adjustable Power consumption: 1.5 kw Operating voltage: 230V/60HZ 3-phase Control voltage: 24V DC Oil capacity: 50 liters (13.2 gallons) Oil viscosity: ISO 100 cST Compressed air supply: 6 bar (90 psi) Compressed air consumption: approx. 3 liters per loading cycle Weight (approx.): 1,650 lbs Includes: (1) Guide channel set of your choice (channel sections, pusher & revolving tip (1) Universal telescopic nose with I.D. liner (1) O.D. bar stock pusher collet (1) Custom lathe cable & interface plug (1) Polyurethane bushing blocks (one set includes upper & lower pieces) Swiss Headstock Synchronization Device Automatic Remnant Retraction, Self Centering Gripper FMB Minimag 20 12' 2 Guide Channel Set Complete Package Includes (2) Channel Sets, (2) Pushers, (2) Nose Liners, (2) Pusher Collets & (2) Sets of Bushing Blocks $33,200.00 Optional Accessories - Prices Subject to Change: Installation: $ 3,300.00 (includes labor and travel expenses to most areas in North America) Additional Guide Channel Sets: $ 2,675.00 ea (includes pusher, revolving tip, nose liner & spindle liner) Additional Spindle Liners: $ 420.00 ea. (needed when selecting a guide channel set whose max. bar diamater is smaller than the draw tube of the lathe) Additional Bar Stock Collets: $ 110.00 ea. Polyurethane Support Blocks: $ 120.00 ea. (one set includes upper & lower pieces) Movable Anti-Vibration Device: $ 2,400.00 ea. Dual Channel safety kit $ 500.00 Long Pusher Kit $ 3,700.00 Axial Shift Device with Safety Switches $ 2,600.00 Bar Feeder installation does not include lathe-side software or hardware interface. This interface must be supplied and installed by the lathe OEM or dealer prior to bar feeder installation. The anchoring of the FMB bar feeder to the floor is a requirement and will be performed by the service technician.
to complete inventory display
to our home page