General Specifications per Manufacturer Bar Capacity: No Prep: 3mm to 33.2mm (.118" to 1.312") With Prep: 3mm to 38 mm (.118" to 1.500") Maximum Bar Length: 12'6" Minimum Bar Length: 39.4" Maximum Remnant Length: 16" Magazine Rack Capacity: 12" Bar Loading Cycle: 30 seconds for 12' bar Material Straightness Specifications: .007"TIR/ft of material (V Blocks, 3 points equidistant) Feed Force (pusher torque): max 450N, adjustable Foward Feed Rate: 750 inches/min max, adjustable Return Feed Rate: 1000 inches/min max, adjustable Power Consumption: 1.5kW Operating Voltage: 230V/60 Hz - 3 phase Control Voltage: 24V DC Oil Capacity: 57 liters (15 gallons) Oil Viscosity: ISO 100cST Compressed Air Supply: 6 bar (90 psi) Compressed Air Consumption: approx. 8 liters per loading cycle Weight (approx): 2,100 lbs Dimensions (approx.): 16' x 2' x 4.25' Includes: (1) Guide channel set matched to the lathes capacity (1) Telescopic nose to match guide channel set (1) Barstock collet (1) Outboard anti-vibration device bushing block set (1) Swiss style synchronization and lathe adaption kit (1) Custom lathe cable & interface plug Edge Patriot 338/12' 2 Guide Channel Set Complete Package Includes (2) Channel Sets, (2) Pushers, (2) Telescopic Noses, (2) Pusher Collets & (2) Sets of Bushing Blocks: $34,500.00 Edge Patriot 338/8': $27,995.00 Edge Patriot 338 8' 2 Guide Channel Set Complete Package Includes (2) Channel Sets, (2) Pushers, (2) Telescopic Noses, (2) Pusher Collets & (2) Sets of Bushing Blocks: $30,995.00 Optional Accessories - Prices subject to change without notice: Installation: $3300.00 Additional Guide Channel Set: $ 3500.00 (includes pusher, revolving tip, nose liner & spindle liner (suggested for 10mm and below) Spindle Liner: $420.00 each (needed when selecting a guide channel set other than the lathes max. cap) Bar Stock Pusher Collets (specific collet required for each bar diameter): For bar stock OD's up to 38MM $165.00each Bushing Blocks for outboard Anti-Vibration device: (1) set includes upper & lower pieces: $160.00 each Moveable Anti-Vibration Bushing Blocks Required for Profiled Material (8mm - 20mm - 30mm): $220.00 Dual channel Safety kit $500.00 High Voltage Kit (Required for some lathes):$1,500.00 Axial Shift Device w/ Safety Switches $2,000.00 Long Pusher Kit $2,900.00 Tall Stands $2,500.00 for lathes with Spindle center >1250mm Bar Feeder installation does not include lathe-side software or hardware interface. This interface must be supplied and installed by the lathe OEM or dealer prior to bar feeder installation. The anchoring of the FMB bar feeder to the floor is a requirement and will be performed by the service technician.
to complete inventory display
to our home page