(New) BAR CHAMP #115-JB-B3, 3HP, 360 RPM, 1/2" - 4-1/2" ROUND, 41" BAR HEIGHT   Our stock number: 291995

(New) BAR CHAMP #115-JB-B3, 3HP, 360 RPM, 1/2 - 4-1/2 ROUND, 41 BAR HEIGHT 

General Specifications As Per Brochure

Bar Capacity:
   Round:                               1/2" - 4-1/2"
   Hex:                                 3-3/4"
   Square:                              3"
Bar Height:                             41"
HP:                                     3
RPM:                                    360
Min. Part Length:                       18"
Mach. Width:                            41"
Mach. Length:                           40"
Weight (Approx):                        660 lbs
Equipped with (must be verified by buyer):
   30 degree Chamfer tool standard w/3/4" square 8 sided carbide insert
   3-jaw chuck.  Chuck & bar remain stationary, the cutter revolves around
     the bar.
   Single speed positive drive gear box (no blets to slip or adjust)
   230/460 volt, 3 phase, 60hz motor & switch
   Adjustable bar & slide stops for consistent chamfering
   Ball bearing ways
   Removable chip pan
   Bar support stand
Optional Equipment

** Prices subject to change without notice ***

Air Operated Chucking (Actuators, Valves, & Brackets Included) $1,750.00
Variable Speed (AC Inverter with 3 HP Motor) (58 - 700 R.P.M.)
For deep chamfers on hard or difficult to machine materials ...$1,750.00
Mist Spray Coolant System (May be recommended for deep chamfers on
difficult to machine materials) ...............................$  445.00
Cutting Oil Drip System+
(For deep chamfers on difficult to machine materials) .........$  695.00
Square Stock Adapter (Up To 2") (One Needed For Each Dia) .... $  195.00
Additional Bar Support Stand, 2,000 Lb. Capacity ..............$  225.00
Turn and Chamfer Toolholder (#5279) with Inserts 
 (Fits in Standard Cutterhead)................................ $  425.00
-Replacement Inserts (TPMT 3252MF) .....................(each) $   29.00
Additional 30-Degree Chamfer Toolholder (#5069) 
 with 3/4" Carbide Insert .....................................$  345.00
-Replacement 3/4" insert for #5069 Toolholder (SNMP-643) ......$   27.00
-Replacement Insert Screw for #5069 Toolholder (0530641) ......$   16.50
Tube Head Assembly (For simultaneous ID & OD Deburring and Facing
of Tubing) This Clamps Into the standard 300-1 series cutterhead
(ID, OD, and Facing Cartridges & Inserts included) ............$  975.00
Special Toolholders (Alternate degree chamfer, Special length Turn and+
Chamfer, Chamfer and Face, etc.) ..............................   Quoted

For a quote on this machine, please complete the form below or contact us directly.

Company:
Contact:
Email:
Address:
City St ZIP:
Tel:
Fax:

How did you hear of us?
Additional information on your request:
   

Please enter text from above:

RETURN to listing display       RETURN to our home page